Tom’s Dresser: Sliding Dovetails, part 2

Beginning to look like a case
Beginning to look like a case

I created a taller auxiliary fence for the router table because of the tall panels that will run vertically past the dovetail bit. Making it out of one piece also helps to keep the panels flush during the routing operation. Feather boards are also used before and after the bit.

These cuts were done in small increments until I had a sufficiently tight fit. The micro-fence adjustment feature of the Woodpecker’s router table was much appreciated this task.

Stop cuts (of the sliding dovetails) were made with back saw and chisel.

With the sliding dovetails ready we did a dry assembly of the sides, case top, bottom and horizontal divider. It is beginning to look like a case.

Leave a Reply

Your email address will not be published. Required fields are marked *