Tom’s Dresser – Side Assemblies

Side assemblies
Side assemblies

Side panels are attached to legs to form the dresser sides. Interior surfaces are flush to accommodate drawer web frames. There is an approximate 1/8 inch reveal on outer surfaces [from legs to side panels]. Lots of long grain surface, so three floating tenons are mostly to aid alignment during glue up.

Today I did a dry fit and began to plan and mark up joinery for case top and bottom to the side assemblies. I’ll be using half blind dovetails for top and stopped sliding dovetail at the base to create the base.

Leave a Reply

Your email address will not be published. Required fields are marked *