The top for this piece uses my old-growth, sinker Honduras Mahogany from Greener Lumber, LLC. One edge (one side only) had some severe cracks and voids. I filled those with tinted epoxy, then milled the top. After cutting to overall dimensions, I created gentle curves on each edge. Those cuts were cleaned up with rasps and sandpaper followed by routing a round over both top- and under-side.
The legs have fat, stub tenons so corresponding mortises were cut with a straight router bit and chisel. A Buhl-diamond was cut on the underside with V-chisel and final sanding prepared the piece for finishing.